Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| en:iot-open:practical:hardware:sut:stm32:emb1a_1 [2024/03/03 09:32] – [FAQ] ktokarz | en:iot-open:practical:hardware:sut:stm32:emb1a_1 [2024/03/25 08:23] (current) – [Project information] pczekalski | ||
|---|---|---|---|
| Line 89: | Line 89: | ||
| **What PWM frequency should I use?**: It depends on the signal use. For the fan or LEDs, no specific frequency is required, but for the servo, the frequency needs to be precisely 50Hz. If you use a servo and fan in the same project set the timer frequency at 50Hz. | **What PWM frequency should I use?**: It depends on the signal use. For the fan or LEDs, no specific frequency is required, but for the servo, the frequency needs to be precisely 50Hz. If you use a servo and fan in the same project set the timer frequency at 50Hz. | ||
| + | <WRAP noprint> | ||
| ===== Project information ===== | ===== Project information ===== | ||
| {{: | {{: | ||
| Line 105: | Line 106: | ||
| {{: | {{: | ||
| </ | </ | ||
| - | + | </ | |
| - | + | ||
