Differences

This shows you the differences between two versions of the page.

--- en:hardware:homelab:communication:atmega128mod [2010/11/21 20:25] – raivo.sell
+++ en:hardware:homelab:communication:atmega128mod [2020/07/20 09:00] (current) – external edit 127.0.0.1
@@ Line 3: / Line 3: @@
 When using the old Controller module (ATmega128) and version 5 Communication module following modification have to be performed to avoid conflicts of MAX232 drivers.
-It is necessary to disconnect the MAX232 driver Rx1 on the Controller module. By using the soldering iron heat the pad 9 (see picture below) and blend the pin up with a small screw driver. All other pins of the MAX232 driver can be leaved as they are and in case of later need the disconnected pin can be easily connected again.
+It is necessary to disconnect the MAX232 driver Rx1 on the Controller module. By using the soldering iron heat the pad 9 (see picture below) and bend the pin up with a small screw driver. All other pins of the MAX232 driver can be left as they are and in case of later need the disconnected pin can be easily connected again.
 [{{  :examples:communication:max232_pin9.jpg?580  |MAX232 driver and Rx1 pin}}]
-[{{  :examples:communication:max232_modification.jpg?580  |Heating and blending the pin up}}]
+[{{  :examples:communication:max232_modification.jpg?580  |Heating and bending the pin up}}]

en/hardware/homelab/communication/atmega128mod.1290371154.txt.gz · Last modified: 2020/07/20 09:00 (external edit)