Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:iot-open:remotelab [2019/10/29 19:45] – pczekalski | en:iot-open:remotelab [2020/07/20 09:00] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 15: | Line 15: | ||
| **SUT The Silesian University of Technology, laboratories location: | **SUT The Silesian University of Technology, laboratories location: | ||
| + | All nodes are using NodeMCU v.3 (ESP-12E) MCUs. | ||
| * Node 1 and Node 3 [[en: | * Node 1 and Node 3 [[en: | ||
| * Node 2 and Node 4 [[en: | * Node 2 and Node 4 [[en: | ||
| + | * Node 5 roboarm (under maintenance) | ||
| * Node 6 [[en: | * Node 6 [[en: | ||
| + | * Node 7 rooftop (under maintenance) | ||
| + | * Node 8 through 11 [[en: | ||
| + | |||
| + | <figure sutphysicallabs> | ||
| + | {{: | ||
| + | < | ||
| + | </ | ||
| + | |||
| + | |||
| + | Laboratory provides access to the uniform WiFi, private and separated network with MQTT and NodeRED services able to relay and route application-level messages to and from the Internet (devices remain separated, however). This way you can contact any of the nodes as they present themselves in a single IPv4 " | ||
| + | Nodes 1 through 4 are in a physical distance able to " | ||
| + | Nodes 8 through 11 are in a physical distance able to " | ||
| + | Node 6, node 7 and node 5 are in physically distant locations so there is no warranty that setting up the device as AP enables to connect to them from any other node. If you want to implement communication scenarios independent on the provided WiFi AP, please note to use VRELs 1 through 4 or 8 through 11. | ||
| + | |||
| **ITT Group, laboratories location: Tallinn, Estonia** | **ITT Group, laboratories location: Tallinn, Estonia** | ||
| + | All nodes are using ESP8266 MCUs | ||
| * Node 1 [[en: | * Node 1 [[en: | ||
| * Node 2 [[en: | * Node 2 [[en: | ||
| **UME University di Messina, laboratory location: Messina, Sicilia, Italy** | **UME University di Messina, laboratory location: Messina, Sicilia, Italy** | ||
| + | Nodes 1 through 5 use Arduino Uno with Ethernet Shield while Node 6 uses Arancino board. | ||
| * Node 1-5 [[en: | * Node 1-5 [[en: | ||
| * Node 6 [[en: | * Node 6 [[en: | ||
