Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| en:hardware:avr-can:the_lcd-display [2010/04/05 09:59] – created mikk.leini | en:hardware:avr-can:the_lcd-display [2020/07/20 09:00] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== The LCD-display | + | ====== The LCD Display |
| Another way to visualize the CAN messages is to connect the LCD display as | Another way to visualize the CAN messages is to connect the LCD display as | ||
| - | shown on the photo below. The display will show all messages transmitted on | + | shown in the photo below. The display will show all messages transmitted on |
| - | the CAN bus with its message ID. Therefor | + | the CAN bus with its message ID. Therefore |
| HEX-file (candisplay.hex) to the ATMega32 to which the display should be con- | HEX-file (candisplay.hex) to the ATMega32 to which the display should be con- | ||
| - | nected. | + | nected. |
| - | the attached display and the board will not be able to send messages. Before the | + | the attached display, and the board will not be able to send messages. Before the |
| controller can display the messages the baud rate has to be selected. | controller can display the messages the baud rate has to be selected. | ||
| it the keys on the board (" | it the keys on the board (" | ||
| used. " | used. " | ||
| - | 1Mbps. When the desired baud rate is shown in the display it has to be con- | + | 1 Mbps. When the desired baud rate is shown in the display it has to be con- |
| firmed by pressing " | firmed by pressing " | ||
| the display. | the display. | ||
