This is an old revision of the document!
−Table of Contents
Programmer
Programmer board
Programmer in enclosure
Connectors
Programmer connectors
ARM-CAN Programmer has two connectors: USB to connect the Programmer to PC and JTAG to connect the Programmer to ARM-CAN Controller. To recognize the connectors the Programmer has to be held like shown on the picture.
JTAG
JTAG connector
Programmer board has standard 20-pin JTAG connector with essential pins for programming and debugging. When voltage is detected on VREF pin, red light on the Programmer board lights up.
USB
Programmer board has USB micro-AB connector to connect it with the PC.
