Differences

This shows you the differences between two versions of the page.

--- en:hardware:arm-can:programmer [2010/05/27 15:08] – mikk.leini
+++ en:hardware:arm-can:programmer [2020/07/20 09:00] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
 ====== Programmer ======
+[{{  :images:hardware:arm-can:modules:programmer_enclosure.jpg?250|Programmer module}}]
+/*
 [{{  :images:hardware:arm-can:modules:programmer.jpg?250|Programmer board}}]
+*/
 ===== Features =====
@@ Line 28: / Line 31: @@
 [{{  :images:hardware:arm-can:connectors:programmer_connectors.png|Programmer connectors}}]
-ARM-CAN Programmer has two connectors: USB to connect the Programmer to PC and JTAG to connect the Programmer to ARM-CAN Controller. To recognize the connectors the Programmer has to be held like shown on the picture.
+ARM-CAN Programmer has two connectors: USB to connect the Programmer to PC and JTAG to connect the Programmer to ARM-CAN Controller. To recognize the connectors the programmer has to be held as shown in the picture.
 ~~CL~~
@@ Line 37: / Line 40: @@
 ~~CL~~
-Programmer board has standard 20-pin JTAG connector with essential pins for programming and debugging. When voltage is detected on VREF pin, red light on the Programmer board lights up.
+Programmer board has standard 20-pin JTAG connector with essential pins for programming and debugging. When voltage is detected on VREF pin, a red light on the Programmer board lights up.
 ==== USB ====
 Programmer board has USB micro-AB connector to connect it with the PC.
+/*
 ===== Schematics =====
   * {{:datasheets:arm-can:programmer.pdf|Schematics}}
+*/

en/hardware/arm-can/programmer.1274972913.txt.gz · Last modified: 2020/07/20 09:00 (external edit)