Differences

This shows you the differences between two versions of the page.

--- en:hardware:arm-can:programmer [2010/04/05 09:55] – created mikk.leini
+++ en:hardware:arm-can:programmer [2020/07/20 09:00] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
 ====== Programmer ======
-[{{  :images:hardware:arm-can:programmer_pcb.jpg?250|Programmer board}}]
+[{{  :images:hardware:arm-can:modules:programmer_enclosure.jpg?250|Programmer module}}]
-[{{  :images:hardware:arm-can:programmer_assemled.jpg?250|Programmer in enclosure}}]
+/*
-[{{  :images:hardware:arm-can:programmer_board_1.png?250|Rendered view}}]
+[{{  :images:hardware:arm-can:modules:programmer.jpg?250|Programmer board}}]
+*/
-**Connectors**
+===== Features =====
-  * JTAG 20-pin header
+**Programmer**
-  * USB micro-B receptacle
+  * FTDI FT2232D USB-JTAG converter.
+  * Compatible with Stellaris Flash programmer software.
+  * Can download and debug program.
+**Power supply**
+  * Powered from USB bus.
+  * Green power-on LED and red target-connected LED.
+**Physical**
+  * Dimensions 33 x 31 x 12 mm
+  * Weight ~8 g
+  * Optional housing
+~~CL~~
+===== Connectors =====
+[{{  :images:hardware:arm-can:connectors:programmer_connectors.png|Programmer connectors}}]
+ARM-CAN Programmer has two connectors: USB to connect the Programmer to PC and JTAG to connect the Programmer to ARM-CAN Controller. To recognize the connectors the programmer has to be held as shown in the picture.
+~~CL~~
+==== JTAG ====
+[{{:images:hardware:arm-can:connectors:programmer_jtag.png|JTAG connector}}]
+~~CL~~
+Programmer board has standard 20-pin JTAG connector with essential pins for programming and debugging. When voltage is detected on VREF pin, a red light on the Programmer board lights up.
+==== USB ====
+Programmer board has USB micro-AB connector to connect it with the PC.
+/*
+===== Schematics =====
+  * {{:datasheets:arm-can:programmer.pdf|Schematics}}
+*/

en/hardware/arm-can/programmer.1270461329.txt.gz · Last modified: 2020/07/20 09:00 (external edit)