Differences

This shows you the differences between two versions of the page.

--- en:iot:examples:debugging:realterm [2021/03/11 14:52] – admin
+++ en:iot:examples:debugging:realterm [Unknown date] (current) – external edit (Unknown date) 127.0.0.1
@@ Line 2: / Line 2: @@
 You can download it from [[https://sourceforge.net/projects/realterm/|here]]
+At the end of the installation make sure the **"register Realterm automation server and aux wrapper"** option is checked.
+{{:en:iot:examples:debugging:regwrapper.png?600|}}
+====RealTerm Setup====
+NB: Before using RealTerm first connect the module to the PC and download/install the CH341SER driver [[http://www.wch-ic.com/downloads/CH341SER_ZIP.html|here]]. More info can be found [[https://robolabor.ee/homelab/en/iot/examples/setup|here]]
+===Connect to device===
+Under **Port** set the **Baud** to **115200** and **Port** to the a device serial. To update the new settings press the **Change** button or press the **Open** button so it gets unselected and then press it again.
+{{:en:iot:examples:debugging:setportbaud.png?600|}}
+If you are successfully connected you should see the outgoing device information in the upper panel.
+To remove some of the text artifacts change the Ascii option under **Display**.
+{{:en:iot:examples:debugging:ascii.png?200|}}
+===Sending information===
+To send information you can do so under **Send** and entering text or numbers into one of the two textboxes. To send text press the **Send ASCII** button.
+{{:en:iot:examples:debugging:sendascii.png?600|}}
+To see the information you send go under **Display** and check the **Half Duplex** option.
+{{:en:iot:examples:debugging:duplex.png?600|}}
+===Reset the device===
+To reset the device go under **Pins** and press the two **Clear** buttons under **RTS** and **DTR**. After that press **Set** under **RTS**.
+{{:en:iot:examples:debugging:clear.png?600|}}

en/iot/examples/debugging/realterm.1615474342.txt.gz · Last modified: 2021/03/11 10:00 (external edit)